|
|
 |
Part ~ 2 |
CHECK AND REPLACE ANY DAMAGED PARTS (Like the 'O' rings, boots or dust wipers) If you do not have the RST repair kit then use the parts list in order to obtain the correct parts. |
|
| Lightly apply grease to the compression rods (x2) and top out bumpers and insert them back in to the stanchions. |
|
| Grease and replace the bottom out bumpers (x2) back on to the compression rods. |
|
| Apply grease to the inside of the outer legs ensuring coverage of the bushings (x2) and dust wipers (x2). |
|
| Carefully insert the
outer legs back on to the stanchions.
Be careful not to damage the dust wipers. Re fit boots over the dust wipers. |
|
| Replace the bolts
(x2)
inside the stanchions and tighten using a 4mm hex wrench.
NOTE: torque setting = 60kg/cm. |
|
Replace the springs (x2) before using an RST pre load wrench to tighten the adjuster caps (x2) by turning them clock wise. |
|
| Always
remember to: Check fork for correct operation before every ride and after any servicing. Keep the stanchion area clear of dirt and water as this may lead to an increased need for servicing. Never use a high-pressure hose to clean suspension forks. |
|
| Wrong manual? | Need some spare parts? | How about tuning tips? |
